-
General Adhesive room temperature cure. Resistant to Toluene, Ethanol, Aviation Gas and Diesel Fuel. A low viscosity, two component, chemical resistant epoxy system. Post cured material has excellent resistance to most petroleum based fuels and solvents during exposure at ambient and elevated temperatures. CLR 3080 / CLH 6372
-
High Temperature. A single component, 100% solids, low viscosity, impregnating compound for coils and transformers. This product is also suitable for sand casting. CLS 9600
-
A low viscosity, single component, epoxy potting and encapsulating compound. The product has excellent stability and good adhesion to a wide range of substrates. This product meets UL 94-HB flammability requirements. Heat Cure Single Component semi-flexible epoxy potting and encapsulating system. Product is suitable for potting ferrites and pressure sensitive components in electrical and electronic applications. CLS 9611
-
Heat Cure. Single Component semi-flexible epoxy potting and encapsulating system. Product is suitable for potting ferrites and pressure sensitive components in electrical and electronic applications. Low viscosity. The product has excellent stability and good adhesion to a wide range of substrates. This product meets UL94-HB flammability requirements. CLS 9616
-
High temperature clear epoxy. An unfilled, heat resistant, clear laminating system. Products low viscosity gives the system excellent wet-out properties to fibreglass and other reinforcing fibres. The material exhibits high physical strengths and modulus with moderate post cure temperatures. XRD 1014 / XHD 1015
-
Machine dispense friendly, tough, casting epoxy system. Increased flexibility when compared to CLR 1831 family. A two component, low stress, heat cure epoxy system specifically developed for use on instrument and power transformers. The product if filled with non-abrasive fillers, making the product suitable for machine dispensing. The cured material exhibits excellent thermal stability and thermal cycling endurance. Product meets UL 94-HB flammability requirements. XRD 1321 / CLH 5185
-
2:1 machine dispense adhesive. Bonding abrasive wheels and disks. A two component epoxy system suitable for potting, casting and adhesive applications. Product gels quickly and has good thermal cycling endurance. Material is filled with non-abrasive fillers making it suitable for machine dispensing. XRD 1575 / XH6 1418